/var/run/ndc= not created
Mark.Andrews at iengines.com
Mark.Andrews at iengines.com
Tue Jan 4 12:06:28 UTC 2000
>
> Ok it isnt made when named is run - which isnt really a problem as named
> works fine... its just everytime i want to do a named.reboot or .reload
> i get the ndc error i mentioned below:
>
> > > ndc: error: ctl_client: evConnect(fd 3): Connection refused
> > > ndc: error: cannot connect to command channel (/var/run/ndc)
>
> which make perfect sence as the command channel isnt there! Any ideas?
>
Fix the errors reported when named starts. Named requires
/etc/named.conf to be correct or else the command channels are
not created.
Mark
> N
>
> > -----Original Message-----
> > From: Mark.Andrews at iengines.com [mailto:Mark.Andrews at iengines.com]
> > Sent: 30 December 1999 22:51
> > To: Nick Bryant
> > Cc: 'bind-users at isc.org'
> > Subject: Re: /var/run/ndc= not created
> >
> >
> >
> > >
> > > Hi,
> > >
> > > Just installed Bind 8.2.2 (patch 5). It didnt create the
> > /var/run/ndc=
> > > sockets file during make install as it normally does.
> >
> > "make install" does not create this.
> > It is created when named is run and normally destroyed when
> > named exits.
> > >
> > > So now i get errors like:
> > >
> > > ndc: error: ctl_client: evConnect(fd 3): Connection refused
> > > ndc: error: cannot connect to command channel (/var/run/ndc)
> > >
> > > Anyone know how to create it manually?
> >
> > Run named or start it via ndc.
> >
> > Mark
> > >
> > > Thanks
> > >
> > > Nick
> > >
> > >
> > --
> > Mark Andrews, Internet Engines Inc. / Internet Software Consortium
> > 1 Seymour St., Dundas Valley, NSW 2117, Australia
> > PHONE: +61 2 9871 4742 INTERNET:
> > Mark.Andrews at iengines.com
> >
--
Mark Andrews, Nominum Inc. / Internet Software Consortium
1 Seymour St., Dundas Valley, NSW 2117, Australia
PHONE: +61 2 9871 4742 INTERNET: Mark.Andrews at iengines.com
More information about the bind-users
mailing list