Bind 9 with Views: zone transfer refused from master to slave

[Roberto Carna]

Dear, thanks for your help.

As I have shown above, I use two views with a TSIG key for each view, but
the zone transfer doesn't work.

Please can you send me your Bind views configuration if you can, on master
and slave sides?

Thanks a lot again.

Regards!!!

El mié., 3 jul. 2019 a las 17:27, Sten Carlsen (<stenc at s-carlsen.dk>)
escribió:

>
>
> On 03/07/2019 22.14, Grant Taylor via bind-users wrote:
>
> On 7/3/19 2:04 PM, Lightner, Jeffrey wrote:
>
> You have to use separate IPs for the separate views on the master and the
> slave.
>
>
> I thought you could use different TSIG keys to identify different zones
> with a single IP at each end.
>
> Is that not the case?
>
> As far as I am aware the two views must use different keys, with the same
> IP the key (or the view's ACL) is the only thing to distinguish between the
> views.
>
> You can use the same IP for both views at least on the master, I have that
> setup and have for a very long time seen it running without any problem. I
> do not use keys but let view ACL do the work.
>
>
>
>
>
> _______________________________________________
> Please visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe from this list
>
> bind-users mailing listbind-users at lists.isc.orghttps://lists.isc.org/mailman/listinfo/bind-users
>
>
> _______________________________________________
> Please visit https://lists.isc.org/mailman/listinfo/bind-users to
> unsubscribe from this list
>
> bind-users mailing list
> bind-users at lists.isc.org
> https://lists.isc.org/mailman/listinfo/bind-users
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.isc.org/pipermail/bind-users/attachments/20190704/d4c5fb44/attachment.html>