rndc showzone?
Doug Freed
dwfreed at isc.org
Mon Sep 22 14:38:46 UTC 2025
On 9/22/25 06:55, Havard Eidnes via bind-users wrote:
> Hi,
>
> I'm trying to extend my personal "rndc subcommand" reportoire,
> and for this particular problem we're seeing, "rndc showzone"
> would have been useful.
>
> However, in our cases, both with BIND 9.18.39 and BIND 9.20.13
> that command just completes with the message
>
> rndc: 'showzone' failed: failure
>
> and an exit status of 1.
>
> I can't seem to find any trace of this in the logs I've
> configured (that might be a consequence of our logging
> configuration).
>
> I'm wondering "Is this just me and my configuration?"
>
> Regards,
>
> - Håvard
`rndc showzone` requires 'allow-new-zones' to be enabled, either
globally or for the view in which the zone resides. This is likely the
cause of the failure you're seeing. This could perhaps be a little more
obvious in the error message (if possible), or at least in the
documentation.
Note that the command does *not* show the DNS records in the zone, but
rather the named configuration that defines the zone.
-Doug
More information about the bind-users
mailing list