[bind10-dev] MSQ-NG requirements

[Steven Meyer]

Hi,

Michal wrote:
"we already use the message bus heavily and we would have a very hard time changing the system too much"

I am at a disadvantage here because it is not obvious what the messages are that are exchanged between the various modules.  I think I have a handle on the session interfaces for groups for C++ and Python, but I am confused about the point-to-point configuration. Perhaps you have some additional documentation you can share? 

Regards,

Steven
________________________________
Steven Meyer, Ph.D, P.Eng
Director, Research
BlueCat Networks, Inc.
W: 416.646.8400 x751 | C: 647.403.5041| E-mail: smeyer at bluecatnetworks.com
4101 Yonge St.| ste. 502 | Toronto, Canada, M2P1N6.

IPAM, DNS & DHCP Go Virtual
Visit us at www.bluecatnetworks.com

This e-mail and any attachments are for the sole use of the intended recipient and may contain confidential information. If you believe that this e-mail has been sent to you in error, please notify the sender by reply e-mail and delete the message.  Any disclosure, copying, distribution or use of this information by someone other than the intended recipient is prohibited.