[bind10-dev] 答复： Re: b10-auth killed by other process while starting up.

[Tony Xue]

Actually I haven't do any configuration yet. I just install the new version and then tried to start it.

When I do the same thing after installing the old version, it works fine. Is that the new version required a configuration while starting up?

The cosole output that b10-auth killed by other process , the process ID and exit status 256(I remember it was 256).

Thanks
------原始消息------
来自： JINMEI Tatuya / 神明達哉
收件人： xuezxbb at gmail.com
抄送： bind10-dev at lists.isc.org
主题： Re: [bind10-dev] b10-auth killed by other process while starting up.
发送时间： 2012 年 十月 1 日 00:39

At Sun, 30 Sep 2012 08:05:35 +0000,
"Tony Xue" <xuezxbb at gmail.com> wrote:

> I just download the new snapshot release and installed it by overwriting my last snapshot version. When I start the bind10, the console keep returning that b10-auth was killed by another process.
> 
> I don't think I did anything else, what cause that?

If you serve the authoritative zones in-memory, it's probably because
of the recent substantial changes to the in-memory data source
implementation, but I cannot be sure about that just from the above
problem description.  If you don't mind can you show your
configuration (contents of b10-config.db)?

Also, did you see any log output (not on the console, but in files or
syslog) related to b10-auth that indicates the trouble (such as saying
b10-auth failed to load a zone)?

---
JINMEI, Tatuya
Internet Systems Consortium, Inc.