BIND 10 #775: b10-auth should not exit if it cannot bind to ports

[BIND 10 Development]

#775: b10-auth should not exit if it cannot bind to ports
-------------------------------------+-------------------------------------
                 Reporter:  shane    |                Owner:  hanfeng
                     Type:  defect   |               Status:  reviewing
                 Priority:           |            Milestone:
  critical                           |  Sprint-20110419
                Component:           |           Resolution:
  b10-auth                           |            Sensitive:  0
                 Keywords:           |  Add Hours to Ticket:  0
Estimated Number of Hours:  0.0      |          Total Hours:  0
                Billable?:  1        |
                Internal?:  0        |
-------------------------------------+-------------------------------------

Comment (by hanfeng):

 Replying to [comment:8 vorner]:
 > So, in short, the throw must stay there. In case of the first startup,
 if it throws, we might want to catch it and not exit the whole program, at
 last as a short-time workaround, before we make it possible to configure
 things even when they are not running.
 For this point, I don't agree, if every time port binding failed, we
 restart, it will make boss quite busy, during our test last time, we can
 see the server launch and quit for several times. The auth server isn't
 alive or dead, but keep jumping between them, which is quite terrible, you
 even can not get a chance to modify the configure by hand.

 As for the last throw in port config. I have restore it.

 Regards

-- 
Ticket URL: <http://bind10.isc.org/ticket/775#comment:9>
BIND 10 Development <http://bind10.isc.org>
BIND 10 Development