BIND 10 #2216: update query_bench so it will use the new data source config

[BIND 10 Development]

#2216: update query_bench so it will use the new data source config
-------------------------------------+-------------------------------------
                   Reporter:         |                 Owner:  jinmei
  jinmei                             |                Status:  reviewing
                       Type:         |             Milestone:
  defect                             |  Sprint-20120904
                   Priority:         |            Resolution:
  medium                             |             Sensitive:  0
                  Component:         |           Sub-Project:  DNS
  b10-auth                           |  Estimated Difficulty:  3
                   Keywords:         |           Total Hours:  0
            Defect Severity:  N/A    |
Feature Depending on Ticket:         |
        Add Hours to Ticket:  0      |
                  Internal?:  0      |
-------------------------------------+-------------------------------------

Comment (by jinmei):

 Replying to [comment:7 jelte]:

 Thanks for the review.

 > kudos for the -d option :D (started out by first looking at old
 behaviour and found it quite annoying it was almost impossible to figure
 out what it was doing). Though perhaps this should be stderr, sno strong
 opinion though.

 Using stderr may make sense, but from a quick recheck it's not so
 straightforward to specify it from the query_bench code, so I left it
 unchanged in this branch.  In any case we normally won't enable
 logging, so it should be a minor matter.

 > Rest of the changes look good, please merge.

 Okay, thanks, merge done, closing.

-- 
Ticket URL: <http://bind10.isc.org/ticket/2216#comment:8>
BIND 10 Development <http://bind10.isc.org>
BIND 10 Development