BIND 10 #1584: auth::Query NSEC3 support: Wildcard answer case

[BIND 10 Development]

#1584: auth::Query NSEC3 support: Wildcard answer case
-------------------------------------+-------------------------------------
                   Reporter:         |                 Owner:  haikuo
  jinmei                             |                Status:  reviewing
                       Type:  task   |             Milestone:
                   Priority:  major  |  Sprint-20120221
                  Component:         |            Resolution:
  b10-auth                           |             Sensitive:  0
                   Keywords:         |           Sub-Project:  DNS
            Defect Severity:  N/A    |  Estimated Difficulty:  5
Feature Depending on Ticket:  NSEC3  |           Total Hours:  0
        Add Hours to Ticket:  0      |
                  Internal?:  0      |
-------------------------------------+-------------------------------------

Comment (by jelte):

 A few short comments on the above reply:

 - It is not a problem that it took a while, everyone needs to get used to
 the tools and practices on a new project. We're only rushing this specific
 ticket a bit since we really need these NSEC3 things done. Our apologies
 if this made it seem we think you are doing a bad job; we do not think
 that :)
 - While I tend to make-it-work, then clean-it-up too, the latter is a lot
 less work if you stick to the style guidelines even during development.
 Just a tip :)
 - Jinmei did push his changes to branch trac1584review. Have you pulled it
 in correctly?
 {{{
 git checkout trac1584review
 git pull
 }}}
    There's 7 or 8 commits from jinmei there.

-- 
Ticket URL: <http://bind10.isc.org/ticket/1584#comment:12>
BIND 10 Development <http://bind10.isc.org>
BIND 10 Development