BIND 10 #2023: xfrin doesn't send the right command to zonemgr after transfer

[BIND 10 Development]

#2023: xfrin doesn't send the right command to zonemgr after transfer
-------------------------------------+-------------------------------------
                   Reporter:         |                 Owner:  UnAssigned
  jinmei                             |                Status:  reviewing
                       Type:         |             Milestone:
  defect                             |  Sprint-20120619
                   Priority:  high   |            Resolution:
                  Component:  xfrin  |             Sensitive:  0
                   Keywords:         |           Sub-Project:  DNS
            Defect Severity:  N/A    |  Estimated Difficulty:  3
Feature Depending on Ticket:         |           Total Hours:  0
        Add Hours to Ticket:  0      |
                  Internal?:  0      |
-------------------------------------+-------------------------------------
Changes (by muks):

 * owner:  muks => UnAssigned
 * status:  assigned => reviewing


Comment:

 Up for review. I've also moved another xfrin->zonemgr notification into
 isc.notify.

 I also want to add a lettuce check for it, to see that zonemgr is getting
 the correct notification, but my zonemgr is not logging for some reason.
 It just stops logging after ZONEMGR_STARTED.

 ddns also uses ZONE_NEW_DATA_READY_CMD. I'm not sure if
 'zone_new_data_ready' was really intended, or 'notify'. There are no ddns
 lettuce tests yet to verify (`make check` and existing lettuce tests pass,
 but that's not enough).

 The ddns lettuce tests should be in master soon, at which point this can
 be tested. Until then, the branch can be reviewed.

-- 
Ticket URL: <https://bind10.isc.org/ticket/2023#comment:4>
BIND 10 Development <http://bind10.isc.org>
BIND 10 Development