BIND 10 #2062: bind10-showtech initial version

[BIND 10 Development]

#2062: bind10-showtech initial version
-------------------------------------+-------------------------------------
            Reporter:  shane         |                        Owner:
                Type:  task          |                       Status:  new
            Priority:  medium        |                    Milestone:  Next-
           Component:  Unclassified  |  Sprint-Proposed
           Sensitive:  0             |                     Keywords:
         Sub-Project:  Core          |              Defect Severity:  N/A
Estimated Difficulty:  0             |  Feature Depending on Ticket:
         Total Hours:  0             |  bind10-showtech
                                     |          Add Hours to Ticket:  0
                                     |                    Internal?:  0
-------------------------------------+-------------------------------------
 We need to build an initial bind10-showtech utility. A proposal about the
 contents is on the ShowTech page.

 This could be a Python script, or a shell script, as appropriate. Much of
 the output will be unavoidably system dependent, however some can and
 should come from standard BIND 10 installation (for example, we need to
 put config.log in a place where it can be found after installation).

 ISC's support was asked for the most important information in a DHCP
 context, and have said the most important information is:

 * OS and version
 * dhcpd.conf file (or BIND 10 configuration in our case)
 * Lease file (zone contents in our case)
 * Log information
 * List of network interfaces
 * core file (if it crashed)

 Since configuration and zone contents can both be quite big, probably we
 can leave those out of the initial version. Perhaps these can be added
 later with something like "bind10-showtech --with-zone-contents" and
 "bind10-showtech --with-full-config".

-- 
Ticket URL: <http://bind10.isc.org/ticket/2062>
BIND 10 Development <http://bind10.isc.org>
BIND 10 Development