BIND 10 #1742: Have message compiler exit with an error if a duplicate message ID is detected

[BIND 10 Development]

#1742: Have message compiler exit with an error if a duplicate message ID is
detected
-------------------------------------+-------------------------------------
            Reporter:  stephen       |                        Owner:
                Type:  enhancement   |                       Status:  new
            Priority:  minor         |                    Milestone:  New
           Component:  message-      |  Tasks
  library                            |                     Keywords:
           Sensitive:  0             |              Defect Severity:  N/A
         Sub-Project:  DNS           |  Feature Depending on Ticket:
Estimated Difficulty:  0             |          Add Hours to Ticket:  0
         Total Hours:  0             |                    Internal?:  0
-------------------------------------+-------------------------------------
 Ticket #1741 reports a case where a duplicate ID is used in a message
 file.  This was only noticed by chance, as the message compiler outputs a
 warning message but otherwise exits normally.

 The message compiler should be modified to output an error message when
 this condition is detected, and to exit with a non-zero status.  That
 would cause a build to stop when a duplicate ID is found and so make the
 problem more obvious.

-- 
Ticket URL: <http://bind10.isc.org/ticket/1742>
BIND 10 Development <http://bind10.isc.org>
BIND 10 Development