BIND 10 #1707: Default configuration was used when mistake in different configuration

[BIND 10 Development]

#1707: Default configuration was used when mistake in different configuration
-------------------------------------+-------------------------------------
                   Reporter:  jreed  |                 Owner:
                       Type:         |                Status:  new
  defect                             |             Milestone:
                   Priority:         |  Sprint-20120403
  medium                             |            Resolution:
                  Component:         |             Sensitive:  0
  b10-auth                           |           Sub-Project:  DNS
                   Keywords:         |  Estimated Difficulty:  4
            Defect Severity:  Very   |           Total Hours:  0
  High                               |
Feature Depending on Ticket:         |
        Add Hours to Ticket:  0      |
                  Internal?:  0      |
-------------------------------------+-------------------------------------

Comment (by jinmei):

 Replying to [comment:9 jelte]:

 > Didn't we at some point simply fail to start if the initial
 configuration was bad? Maybe that would be a good interim solution while
 we discuss and plan more invasive changes. Though that would make bind10
 fail to run completely, which is obviously also not ideal.

 I guess, regardless of whether it's a short term workaround or part of
 a larger change, the revised b10-auth should fail to run if it cannot
 even install initial configuration because there's no other fallback
 config in that case.  Some errors may be safely ignore in practice,
 but that depends on the operation policy so we cannot be sure.

-- 
Ticket URL: <http://bind10.isc.org/ticket/1707#comment:10>
BIND 10 Development <http://bind10.isc.org>
BIND 10 Development