"Reserved" statement
David W. Hankins
David_Hankins at isc.org
Wed Jan 3 18:35:51 UTC 2007
On Fri, Dec 22, 2006 at 09:30:47PM +0900, Michael Kwok wrote:
> I read about the "reserved" keyword in the manual and was wondering where to
> place it in the config so that the server serves the same address to the
> same client.
It isn't a dhcpd.conf directive, it's a dhcpd.leases directive (since
this is a failover feature, it represents dynamic state, rather than
statically configured state).
Just insert it into the lease {} stanza of your choosing (dhcpd
should be stopped first, restarted after).
I think we put in OMAPI wrenches to update the lease dynamically,
but I can't tell you a lot about that, and it would be bad advice
to send you down that maze of twisty passages.
There will be a command-line interactive way to do this in a future
release.
--
David W. Hankins "If you don't do it right the first time,
Software Engineer you'll just have to do it again."
Internet Systems Consortium, Inc. -- Jack T. Hankins
More information about the dhcp-users
mailing list