moran at ti.com
Wed Jul 18 09:02:33 UTC 2007
That helped thanks.
Though I do have other issue with the configuration file.
The address on which I want to accept the DHCP messages is on
2001:200::30 on eth0 (I have other addresses on that interface).
I got this message when I tried to run the DHCP"
"No subnet declaration for 2001:200::30 (no addresses).
** Ignoring requests on 2001:200::30. If this is not what
you want, please write a subnet declaration
in your dhcpd.conf file for the network segment
to which interface 2001:200::30 is attached. **"
From: dhcp-users-bounce at isc.org [mailto:dhcp-users-bounce at isc.org] On
Behalf Of David W. Hankins
Sent: Tuesday, July 17, 2007 7:41 PM
To: dhcp-users at isc.org
Subject: Re: DHCPV6 Problems
On Tue, Jul 17, 2007 at 05:39:25PM +0200, Birenbaum, Moran wrote:
> I did that but then I received error messages when I used the make
Looks like there's a dependency problem somewhere. Try:
make clean ; make
The build system is something we're still working on. I notice
from your output that your local system re-did autoconf. That makes
it hard to predict results. This is a bug in both our release process
and our build environment which we're working on.
Ash bugud-gul durbatuluk agh burzum-ishi krimpatul.
Why settle for the lesser evil? https://secure.isc.org/store/t-shirt/
David W. Hankins "If you don't do it right the first time,
Software Engineer you'll just have to do it again."
Internet Systems Consortium, Inc. -- Jack T. Hankins
More information about the dhcp-users