So here is another perhaps better usage example of the ISC DHCPv6 Relay Agent.  Is this scenario I have a dual stack linux host where the relay agent is installed and running:<div><br></div><div><div>./dhcrelay -I -l eth1 -u eth0</div>
<div><br></div><div>eth0 is the server link, eth1 is the client link</div><div><br></div><div>Upon starting the ISC DHCPv6 client I see the following log messages:</div><div><br></div><div><div>Dec  8 23:09:32 krakow dhcrelay: Relaying Solicit from fe80::260:8ff:fed1:d51f port 546 going up.</div>
<div>Dec  8 23:09:32 krakow dhcrelay: send_packet6: Cannot assign requested address</div><div><br></div><div>Looking at the code now to see if I can figure out what is happening, wanted to see if anyone else is seeing this behavior.</div>
<div><br></div><div>John</div><br><div class="gmail_quote">On Thu, Dec 4, 2008 at 1:17 PM, John Jason Brzozowski <span dir="ltr"><<a href="mailto:jjmbcom@gmail.com">jjmbcom@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;">
I am kicking the tires on the ISC DHCPv6 Relay Agent, here is my scenario:
<div><br></div><div>client -> relay -> (link0) router  (link1) -> server</div><div><br></div><div>The client and relay are ISC and on the same link.</div><div><br></div><div>A router stands between the client/relay and the server.</div>

<div><br></div><div>I wish to use the relay which is local to the client which has only one interface to relay DHCPv6 traffic to the server on a different link.  The syntax for the relay agent is not crystal clear to me.  I looking all over the place for examples and even perused the code a bit.  Hitting the list now to see what sort of feedback I might get</div>

<div><br></div><div>Here is what I used to try and start the relay agent.</div><div><br></div><div>The relay agent did not even start using the below:</div><div><br></div><div>./dhcrelay -d -l eth0 -u 2001:558:ff10:8a0:10:252:24:82<br>

</div><div><br></div><div>This usage does not make sense nor does it do anything:</div><div><br></div><div>./dhcrelay -d -l eth0 -u eth0<br></div><div><br></div><div>Wondering if there is a way to tell the relay agent to listen for traffic on interface X and relay or forward traffic to interface Y or IPv6 address(es)?</div>

<div><br></div><font color="#888888"><div>John</div>
</font></blockquote></div><br><br clear="all"><br>-- <br>===================================<br>John Jason Brzozowski<br>===================================<br>
</div></div>