<div dir="ltr">First, your config isn't correct. You have both the primary and secondary configured with the same IP address. My statement is based on the small configuration snippet included in your post. I'd be happy to review your full config offline at your convenience.<div><br></div><div>Second, I said that this was THEORETICALLY possible. While I think I see what you are trying to do, I don't see why you are trying to do it. Client distribution across members of a failover pair is controlled by the split parameter. Defining each member as a primary and a secondary on separate failover pairs and then assigning a particular failover pair at the subnet level would simply increase the amount of computing cycles spent within the individual servers due to the increased complexity of the configuration also resulting in increased knowledge needed at the troubleshooting level.</div><div><br></div><div>Third, ISC DHCP is now EOL (as of Dec 2022). Give some serious consideration to looking into moving to ISC's new KEA product. Yes, there is a learning curve involved. However, you already have a cursory understanding of DHCP. You'll have no issues converting.</div><div><br></div><div>Regards,</div><div><br></div><div>Bob</div></div>