[kea-dev] Check kea configuration
Marcin Siodelski
marcin at isc.org
Thu Mar 19 10:03:44 UTC 2015
Yes, I think it would be useful. Can you please open a ticket?
Marcin
W dniu 2015-03-19 o 09:43, Chaigneau, Nicolas pisze:
> Hello,
>
>
> Is it possible to check that Kea's configuration is valid, without actually trying to start the server ?
>
> (if not, would it be possible to add this, perhaps with a new command line parameter to kea-dhcp4 for instance ?)
>
>
> I think of this because, from my experience, it is very easy to botch the configuration. (For instance, a comma not removed at the end of a list. I'm doing this quite often.)
> That's not really an issue in development: you notice it fails to start, the message displayed allows to precisely locate the issue. You just fix the configuration, and start again.
>
> But in production, Kea will be run on several nodes of a cluster. The server will be restarted through the cluster.
>
> If the configuration is incorrect, the cluster will not be happy, and it will be more difficult to figure out what went wrong and restore a nominal cluster situation.
>
> So it would be really useful to be able to check a configuration, before actually try to start or reconfigure the server with this configuration.
>
>
> What do you think ?
>
>
> Regards,
> Nicolas.
>
>
> This message contains information that may be privileged or confidential and is the property of the Capgemini Group. It is intended only for the person to whom it is addressed. If you are not the intended recipient, you are not authorized to read, print, retain, copy, disseminate, distribute, or use this message or any part thereof. If you receive this message in error, please notify the sender immediately and delete all copies of this message.
>
> _______________________________________________
> kea-dev mailing list
> kea-dev at lists.isc.org
> https://lists.isc.org/mailman/listinfo/kea-dev
More information about the kea-dev
mailing list