bind 9(.2.4) on solaris 10
Mark_Andrews at isc.org
Tue Jun 6 02:12:49 UTC 2006
> I wish it were that simple for me. Unfortunately I have corporate
> requirements and restrictions to work with and one of them happens to be
> to have IPv6 disabled everywhere. =P
So short sighted ...
One could argue that 6to4 is only IPv4 :-)
> Speaking of which, there appears to be a named.conf directive called
> "listen-on-v6". Would the "listen-on" version imply IPv4 only? If so,
> that would be an acceptable workaround.
No. Named will make queries over IPv6 even if it won't accept
> Mark Andrews wrote:
> > You know there is a simple solution. Get IPv6 connectivity.
> > If your ISP doesn't provide it there are plenty of tunnel
> > brokers that will provide connectivity, often for free.
> > That's how my home network get IPv6 connectivity.
> > If you don't won't is use a tunnel then set up 6to4 support.
> > Mark
> > Note you will need IPv6 connectivity within the next few years.
> > --
> > Mark Andrews, ISC
> > 1 Seymour St., Dundas Valley, NSW 2117, Australia
> > PHONE: +61 2 9871 4742 INTERNET: Mark_Andrews at isc.org
Mark Andrews, ISC
1 Seymour St., Dundas Valley, NSW 2117, Australia
PHONE: +61 2 9871 4742 INTERNET: Mark_Andrews at isc.org
More information about the bind-users