parse problem with pool balance statements
glenn.satchell at uniq.com.au
Wed Mar 16 12:03:13 UTC 2011
On 03/16/11 19:44, Ana Gallardo Gómez wrote:
> Hello Glenn,
> I have use it many times in the past and it describes a nice basic
> failover config. However, it predates the current pool balancing
> algorithm, so it doesn't mention any of these settings:
> Where can I fount the algorithm?? I only found
You could look at the explanation in the dhcpd.conf man page.
> max-lease-misbalance 15;
> max-lease-ownership 10;
> min-balance 60;
> max-balance 3600;
> Since these are the default values anyway, you could just comment
> them out.
> Ok, but I can't use other values.
I understand that. It was a suggestion to help debug the configuration.
> A useful way of debugging these kind of things is to comment out the
> lines that give an error, even if they look right, one at a time.
> Eventually things will either work or it will become apparent which
> line is causing the problem.
> Sometimes the parse engine trips up on a previous line, but doesn't
> report a problem until a following line.
> Thant you for your recomendation and for your response.
No problem. I hope it helps.
More information about the dhcp-users