Strange BUG

[Mark_Andrews at iengines.com]

	Well the error is by default sent to syslog.

	Also named.conf can specify where the control channel is.
	Do you really want a control channel started when it may
	not be where you don't want it to be?

	Mark

>  Hi all,
> 
>  Well ran into a strange little bug today after upgrading a slave
> nameserver. This happens on both slave and master servers. Granted it
> was an error in the conf file...It still shouldn't cause this.
> 
>  The other thing is that this didn't show up in the form of a message in
> 'messages'...Only when logging was turned on did I see this.
> 
>  Ok here it goes....named.conf had the following error on the last zone
> record.
> 
> zone abc.com" {
>         type master;
>         notify no;
>         file "abc.com";
> };
> 
>  You'll notice that it's missing a quote....
> 
>  NDC gives this error :
> 
> ndc> status
> ndc: error: ctl_client: evConnect(fd 3): Connection refused
> ndc: error: cannot connect to command channel (/var/run/ndc)
> ndc>
> 
> 
> An error also shows up in the parse-error.log but only if you have
> logging turned on. Otherwise named starts without a problem. Just
> doesn't load that zone or any below that.
> 
> 23-Nov-1999 11:48:39.536 /etc/named.conf:139: syntax error near
> 'abc.com'
> 23-Nov-1999 11:48:39.537 /etc/named.conf:151: EOF in quoted string
> 
>  Also noticed while running truss on ndc, that it couldn't find the file
> /var/run/ndc (linux) or /usr/local/etc/ndc (solaris).
> 
>  This little error in the named.conf causes this....You put the quote in
> and all works well. The ndc file now gets created and ndc works
> perfectly..
> 
>  Anyone else think this is a problem ???
> 
>  Hope I explained it well enough.... This happens on Solaris 2.6 and
> RedHat 6.0.
> 
>  Mike Smith
> 
> 
--
Mark Andrews, Internet Engines Inc. / Internet Software Consortium
1 Seymour St., Dundas Valley, NSW 2117, Australia
PHONE: +61 2 9871 4742                 INTERNET: Mark_Andrews at iengines.com